Available in cooling only and cooling with hydronic heat models
Cooling from: 7700-15000
Heating: 6300-17000 Btu
Islandaire EZ Series 40 is a replacement for the American Standard models of Type SR 40 units. Our commercial duty construction with heavy gauge galvanized steel and superior components create an efficient reliable unit. This design eliminates the need for any interior or exterior renovation. Use of the existing wall sleeve-cabinet and louver saves time and money, two very important factors in today’s competitive environment! Hydronic coil package available. Hydronic coil must be replaced with Part #: 4090062.
Comfort & Dehumidification
Quiet operation
Intuitive digital or analog controls
Even heat monitoring checks room temperature and automatically adds a heat boost if necessary
Separate thermostat settings (limiting) for cooling and heating modes (digital only)
Samples the room temperature in intervals to monitor and maintain desired temperature
Optional constant fan mode for additional comfort options
Reversible indoor air louvers for an additional airflow direction option
Sound Reduction
New dual motor design allows the indoor motor to run at slower speeds, which reduces indoor sound levels
The quiet, efficient compressor is mounted on vibration isolators, which absorb vibration-causing noise
Permanently lubricated dual motors reduce noise
New tangential fan moves air over a wider area so it’s quieter
Fan turns on before the compressor starts to muffle the sound
Islandaire’s advanced anti-corrosion protection protects the outdoor coil against deterioration and extends unit life, especially in harsh coastal environments
Freeze Protection initiates heat if room temperature falls to 40 °F in an unoccupied room
Stainless Steel endplates on both indoor and outdoor coil
Indoor coil frost sensor protects the compressor
Permanently lubricated fan motors
Tamper-resistant grille
Durable, powder coat paint finish
Health and IAQ
Fresh-air vent
Washable, antimicrobial filters
Energy Usage: Management
Increase or decrease electric heat output by changing the power cord
Set separate heat and cool range limits (digital only)